Replacing Foam Floats at a Marina or Yacht Club: A Planning Guide
Most marinas and yacht clubs in Nova Scotia still have some foam-filled floats in the water. Foam does its job for a while, but over time it waterlogs, crumbles and sheds into the harbour, and the dock sits lower every season. Winter is the best time to plan a replacement so new floats are ready before boats go back in.
Signs your floats are due
Docks or fingers sitting noticeably lower than they used to, or listing to one side
Foam pieces breaking off and collecting along the shoreline
Cracked or split float shells exposing the foam inside
Members complaining about soft, bouncy or uneven walkways
Why foam-free HDPE floats
Docks R Us floats are made from solid-wall HDPE (high-density polyethylene) pipe, seamless and heat-fusion welded so each float is a sealed air chamber with no foam inside. There is no steel to rust and nothing to break down into the water, and the flotation carries a lifetime warranty. They work in both salt and fresh water.
How to plan the replacement
Measure the sections you want to replace: length, width and how many fingers or slips
Note what sits on top: walkway width, finger spacing, any ramps or gangways
Decide whether you need floats only (to put under your existing frames or new framing) or complete dock sections
Send us the sizes or a rough sketch of the layout
For commercial float orders we turn quotes around the same day. Build time is about 14 days, with pickup at our shop in Porters Lake or flatbed delivery across Nova Scotia, New Brunswick, PEI and Newfoundland.
Budgeting for spring
Standard float sets run from 6x12 to 8x24 ft, starting at $1,899.99 plus HST for floats only. Larger or odd-sized commercial orders are quoted from your layout. You can see standard sizes and prices on our pricing page, and more on commercial orders on our work floats page.
Ready to get a number for your board or budget meeting? Call 902-281-3625 or email info@docksrus.ca with your sizes.


Comments